Rapidly Assessing Pouch Cell Flatness With Pressure Mapping System
1. Abstract This article demonstrates a practical, quantitative alternative: using a IEST Battery Pressure Mapping…
-
iestinstrument
Blog
Lithium Metal Batteries With Zero Volume Expansion Composite Anode For High Energy Density and Stability
1. Abstract A roll-to-roll process was developed to fabricate a composite lithium metal batteriesthat exhibits…
Influence of Buffer Foam on the Swelling Thickness and Swelling Force of the Cell Charge and Discharge Process
1. Preface Lithium-ion battery is an electric-heat-force coupling system, which has swelling problems in the…
Battery Storage Gassing Testing Has Never Been Easier!
1. Introduction Gas generation is an unavoidable phenomenon during the battery manufacturing process and its…
In-Situ Swelling Analysis of LiFePO4 Prismatic Cells: The Impact of Preload Force and C-Rate
Abstract This prismatic case study uses an in-situ swelling analyzer (SWE2110) to quantify swelling force and surface…
Silicon Carbon Anode Swelling Percentage and Capacity Decay: A 50-Cycle In-Situ Comparative Study
Abstract Silicon anodes undergo approximately ~300% volume expansion during lithiation — a fundamental challenge that silicon-carbon (Si-C)…
Application of EIS Testing To Lithium Battery On Pressure Condition
Abstract EIS testing on LCO/graphite pouch cells shows that module-level compression pressure increases low-frequency impedance…
Impact of Stiffness Constraints (Linear Regime) on Battery Cell Performance
1. Preface The in-situ swelling analyzer (SWE) launched by IEST has constant pressure and constant…
In-situ Swelling Analysis of NCM Cells Under Different Constant Pressure Conditions
1. Abstract This study utilizes an In-situ Swelling Analyzer (SWE) to investigate the thickness evolution…
Blade Cell Expansion Testing: Insights for Blade Battery Technology and Design
Abstract Blade battery technology refers to a long, thin, blade-shaped lithium-ion cell format — most commonly…
